[ Post a Response | 3D-RACING ]
Posted by chip miller
on 3/23/2009, 8:38 pm
64.12.117.65
2-292 double hump angle plug heads-bare
2-492 double hump 64cc heads complete with big valves just reworked nice!!!
2-882 76cc complete heads need reworked
1-186 double hump head complete
1-487 75cc head complete
1-350 cast crank good cond.
1-350 2 bolt block surface rust in #8 cylinder
1-350 4 bolt block needs freeze plugs & cam bearings
1-350 short block fresh from machine shop
.060 over with keith black hypereutetic pistons
5.7 manley sportsman rods, with arp bolts
1182 forged crank
full balance w/flywheel
adj. timing gear
aftermarket oil pan
solid cam w/push rods and lifters
full arp stud set
1-set of je .030 pistons
1-set of dz 302 pop up pistons & rods.
dual point dist.
accel dist.
stewert water pump
isky roller cam and rollers
two sets of roller rockers 1 new 1 used w/ valve girddles
1-windege tray
2-cast iron intakes
3-stock water pumps
2-3 disk clutchs for a mod.
2-clutch & press. plates
2-alum. flywheels
1-327 block & crank
3-m/t valve covers
1-set of ram horns
1-edelbrock torker intake
1-750 holley double pumper carb.
1-600 holley single feed carb.
2-sets of 3.73 gears for 7.5 rearend
everything you see here $2500
Message Thread:
« Back to thread