Posted by Clyde
on May 18, 2009, 3:16 pm
Attention Bando Families,
Please note that from this point on. All restrictor plates must run in this configuration, see http://www.600racing.com/inex_info/tech_updates/512530.html
The only exception is that you can run either a 2 hole or cut spacer as both of these are "as delivered" from 600.
The most important issue is that the bottom gasket (between the intake and the restrictor plate) must be an uncut, unaltered gasket.
Also note that all bolt holes in the gaskets must have a full circle of gasket material (just like the picture).
Please let me know if you have any questions.
Thanks,
Clyde Hickham
www.HoustonRaceCars.com
Message Thread:
« Back to thread